Home
Contact Us
Freight & Terms
Tank Info
Tank Colours
Search
View Cart
Wholesale
BSP Threads

AcquaSaver Valve
Adaptors BSP/NPT/USGT
Air Release Valves
Aluminium fittings
Brass Nut & Tail
Camlocks
Cartage Tanks
Clamps
Cobra Clips
Controllers
Control cable
Drippers
Drip Line
Drip line Clamps
Fertilizer Injector
Fertilizer Meters
Filters
Fire Fighting
First Flush Diverters
Flanges
Float Switch
Garden 4mm Fittings
Garden poly pipe
Garden Poly fittings
Garden Pop-Up Sprays
Garden Pop-Up Sprinklers
Garden Sprays
Garden Taps
Garden Valves
Gaskets
Grey Water
Hose Fittings
Hose Tails
Hoses
Hose Nozzles
Hose Reels
IBC Fittings
Lawn Sprinklers
Metric Poly Fittings
Misting Valve
Olive Sprinklers
Pipe
Pipe Fittings - Nyglass
Pipe Fittings - Stainless Steel
Pipe Repair Clamps
Pressure Gauges
PRV
Pumps
Pump Covers
PVC Fittings
Rural Poly Fittings
Saddles
Soil Moisture Monitoring
Sprinklers
Storz Fittings
Tank Accessories
Tank Fittings
Tank Pump Kits
Tanks NSW & ACT
Tanks - SQLD
Tanks - Victoria
Tap Connection Kits
Tap timers
Teflon Tape
Threaded Risers
Town Tank Switch
Turf Sprinklers
Travelling Irrigators
Valves
Valve Boxes
Victaulic clamps
Water Meters

Irrigation Warehouse Group Pty Ltd

Tank Accessories



Tank Water Level Display with float

Price:





QTY:

        
Tank Water Level Display with float

Installation Instructions:

You will need a hole cutter in the size range of  45mm - 55mm and a power drill for the hole cutter plus, a driver bit for the stainless steel screws.

1.   Decide on the best location on the top of the tank so that you will be able to easily read the display.   Make sure that the float that will go down into the water does not hit any internal plastic parts if there are any.

2.   Carefully remove the front cover of the display unit.  

3.   Hold the display against the side of the tank at the top and allow the flaot to slowly lower to a point level with the bottom of the tank.  

4.   With your other hand, carefully rotate the display disc so that the needle is pointing to the 0cm mark.

5.   Now slowly lower the display so that the thin cord rewinds.

6.   With the float cord fully retracted inside the display, the display should read the height of the tank.

7.   Check the accuracey by holding the display in one hand at the level of the top of the tank, slowly lower the float to make sure that everything is correct.

8.   Replace the front cover.

9.   Using your hole saw, cut the hole in the top of the tank and remove the plastic that is cut out.

10.  Lower the float down through the hole and make sure that it can move freely.

11.  Now secure the flanged nut to the top of the tank with the 2 stainless steel screws provided.

12.   If the float is sitting on the bottom of the tank, the display should read 0cm, if it does not, remove the front cover and adjust the numbered disc.